Follow these instructions on how to develop a pattern for your vehicle. When the pattern has been developed follow the instructions on how to install the film on your vehicle.
1. Start with a clean car ensure surfaces are completely clean and the paintwork is free from any types of polish.
2. Using sticky tape mark the edges of the area to be covered with film. position low tack tracing paper or you can use tracing paper and 3m low tack spray mount available from Art shops or hobbycraft. or Fablon from DIY shops.
3. Use a soft pencil eg 2B or CD marker pen and draw around the edge to create the film pattern template.
4. Carefully remove the low tack tracing paper or fablon. Using the tacky side carefully position on the paint protection film, carefully cut the film round the template
1. Start with a clean car ensure surfaces are completely clean and the paintwork is free from any types of polish.
2. Using sticky tape mark the edges of the area to be covered with film. position low tack tracing paper or you can use tracing paper and 3m low tack spray mount available from Art shops or hobbycraft. or Fablon from DIY shops.
3. Use a soft pencil eg 2B or CD marker pen and draw around the edge to create the film pattern template.
4. Carefully remove the low tack tracing paper or fablon. Using the tacky side carefully position on the paint protection film, carefully cut the film round the template
Premier Paint Guard
01926 811652
01926 811652
Premier Paint Guard
3M™ Scotchgard™
Paint Protection Film
3M™ Scotchgard™
Paint Protection Film
Always check for trapped foreign material, air or fluid bubbles while applying the film. If any are present gently lift the film and remove. make sure your fingers are wet with application fluid to prevent fingermarks on the film.
As soon as the installation is complete wipe dry and inspect.
If you can't get to the fluid bubbles then gently prick the base of the bubble with a fine pin and squeeze.
If slight silvering or clouding is present under the film after installation this is due to a small amount of fluid and will eventually disappear after 24-48 hours depending on the temperature.
Do not use any waxes that are not recommended for urethanes. Abrasive polishers, colored wax and rubbing compounds are not to be used.
Avoid picking at edges or corners of the film as irreparable damage of the film will result.
When using a high-pressure washer do not place the nozzle directly against the film edges or lifting may occur.
As soon as the installation is complete wipe dry and inspect.
If you can't get to the fluid bubbles then gently prick the base of the bubble with a fine pin and squeeze.
If slight silvering or clouding is present under the film after installation this is due to a small amount of fluid and will eventually disappear after 24-48 hours depending on the temperature.
Do not use any waxes that are not recommended for urethanes. Abrasive polishers, colored wax and rubbing compounds are not to be used.
Avoid picking at edges or corners of the film as irreparable damage of the film will result.
When using a high-pressure washer do not place the nozzle directly against the film edges or lifting may occur.
© PPG all rights reserved
Buy a Template kit, includes styling tape, 3 metres self adhesive film, marker pen click here
© SW-2 marketing 2006. All rights reserved. 3M & Scotchgard are trademarks of 3M - paint protection film-
Select a Link :
